This article mainly introduces:

Turkmenistan hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder

(Turkmenistan unidirectional cylinder,produced by Hengyu Group）

unidirectional cylinder are widely used in Turkmenistan，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed unidirectional cylinder for customers from Turkmenistan.

Introduction to unidirectional cylinder:

If it is found that the unidirectional cylinder lubrication is poor or the unidirectional cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the unidirectional cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the unidirectional cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the unidirectional cylinder center line. In this way, when the piston works in the unidirectional cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the unidirectional cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

The unidirectional cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

The scar on the sliding surface of the unidirectional cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the unidirectional cylinder wall. Therefore, before installation, these scars must be fully repaired.

Piston unidirectional cylinder is widely used in hydraulic transmission. When the unidirectional cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the unidirectional cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the unidirectional cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.

Answers to some questions about unidirectional cylinder:

Why can't the hydraulic cylinder be pulled back after pushing to the limit?
May be long-term use to the limit position, resulting in serious wear caused! The solution is to add the stroke switch or disassemble and add gaskets before and after the piston.

How to remove the cylinder correctly?
(1) Before disassembling the hydraulic cylinder, the hydraulic circuit should be depressurized. Otherwise, when the tubing joint connected with the cylinder is loosened, the high-pressure oil in the circuit will be quickly ejected. The hydraulic circuit of the hydraulic press should first loosen the hand wheel or pressure regulator screw at the relief valve, so that the pressure oil is unloaded, and then block the power supply or block the power source to stop the operation of the hydraulic equipment. (2) When disassembling, it should prevent damage to the top thread of the piston rod, the oil thread, the appearance of the piston rod, the inner wall of the cylinder liner, etc. In order to prevent the piston rod and other slender parts from twisting or deformation, the use of cushion wood support balance when placed. (3) Disassemble in order.