This article mainly introduces:

Thailand hydraulic cylinder,stainless steel cylinder manufacturer,stainless steel cylinder

(Thailand stainless steel cylinder,produced by Hengyu Hydraulic Co., Ltd）

stainless steel cylinder are widely used in Thailand，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed stainless steel cylinder for customers from Thailand.

Introduction to stainless steel cylinder:

How to determine the working pressure of the stainless steel cylinder: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, stainless steel cylinder, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

stainless steel cylinder body inspection: The inner surface of the stainless steel cylinder and the piston seal are the main factors causing the leakage in the stainless steel cylinder, if the stainless steel cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the stainless steel cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

When the piston speed of the stainless steel cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the stainless steel cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

The internal leakage of the stainless steel cylinder should be prevented when the stainless steel cylinder is used. The internal leakage of stainless steel cylinder includes the leakage caused by excessive wear of stainless steel cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

Answers to some questions about stainless steel cylinder:

What's a minus 40 cylinder made of?
Construction with 1Cr18Ni9Ti, in low temperature conditions impact and tensile strength are very good, can withstand -100 degrees of low temperature, corrosion resistance, material price is not very high, more economic.

How to calculate hydraulic cylinder thrust?
Cylinder diameter = piston diameter =200MM Piston area =π (200/2) square =3140 square mm =31.4 square cm 25MPA=250KG/ square cm Maximum thrust = pressure * Piston area =250 *31.4 =7850KG=78500 Newtons This is the maximum thrust. The formula can be derived from the calculation formula.