This article mainly introduces:

New Zealand hydraulic cylinder,forklift lift cylinder manufacturer,forklift lift cylinder

(New Zealand forklift lift cylinder,produced by Hengyu Group）

forklift lift cylinder are widely used in New Zealand，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed forklift lift cylinder for customers from New Zealand.

Introduction to forklift lift cylinder:

forklift lift cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards forklift lift cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the forklift lift cylinder guide is determined by the length of the stroke. Check the strength of forklift lift cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

The pressure of the sliding surface of the forklift lift cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the forklift lift cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

When the piston speed of the forklift lift cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the forklift lift cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

How the cavitation of the forklift lift cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the forklift lift cylinder, resulting in corrosive damage to the parts.

Answers to some questions about forklift lift cylinder:

What should we pay attention to when using the cylinder?
When using the cylinder, we should pay attention to the environment and temperature in which it is located as follows: 1. Before working, the hydraulic cylinder must carry out several reciprocating movements under low pressure (greater than the starting pressure), and work normally after removing the gas in the cylinder. 2. Precautions when removing the hydraulic cylinder: ① The pressure in the hydraulic circuit is reduced to zero before disassembly. ② The screw thread at the top of the piston rod should be prevented from damage when disassembling. ③ Due to the different structure and size of the hydraulic cylinder, the order of disassembly is also slightly different. Generally, the fastening bolt of the end cover should be loosened first. Internal card chain card key application special tools.

How big gear pump need to use for 60*100 cylinder?
One cylinder size alone does not determine the size of the pump used. Choose the size of the pump, at least to know 1, the size of the load is how much, by the size of the load and the size of the cylinder and other conditions can be calculated the pressure required by the hydraulic system. 2. Speed of operation. From this speed and cylinder size, the required flow rate of the system is calculated. The relevant parameters of the pump can be selected by the pressure and flow rate to determine what kind of pump is required.