This article mainly introduces:

Indonesia hydraulic cylinder,hydraulic cylinder for vehicles manufacturer,hydraulic cylinder for vehicles

(Indonesia hydraulic cylinder for vehicles,produced by Hengyu Hydraulic Co., Ltd）

hydraulic cylinder for vehicles are widely used in Indonesia，because of long service life，smooth movement，high work efficiency.So our company has designed hydraulic cylinder for vehicles for customers from Indonesia.

Introduction to hydraulic cylinder for vehicles:

hydraulic cylinder for vehicles buffer valve inspection and maintenance: For the valve buffer hydraulic cylinder for vehicles, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

The hydraulic cylinder for vehicles can not be used as grounding electrode to avoid electric damage to the piston rod.

hydraulic cylinder for vehicles and hydraulic station selection: Select the type and structure of the hydraulic cylinder for vehicles according to the operation requirements of the main engine. According to the external load force borne by the hydraulic cylinder for vehicles, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the hydraulic cylinder for vehicles in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the hydraulic cylinder for vehicles and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the hydraulic cylinder for vehicles, the diameter of the piston and the piston rod.

The assembly work of the hydraulic cylinder for vehicles has a great impact on the quality of the hydraulic cylinder for vehicles: each part must be carefully cleaned before assembly; To correctly install the sealing device everywhere: when installing the sealing ring, pay attention to its installation direction to avoid oil leakage due to installation, and its lip should be equipped with a pressure oil chamber. In addition, because it is a YX-shaped sealing ring, it is necessary to pay attention to distinguish between shaft and hole use, do not install wrong; Because the sealing device is matched with the sliding surface, an appropriate amount of hydraulic oil should be applied during assembly; The special wrench should be used when the threaded coupling is tightened, and the torque should meet the standard requirements; After the piston and piston rod are assembled, it is necessary to measure whether the coaxiality and straightness on the full length are out of whack. After assembly, there should be no blocking sensation and uneven resistance when the piston assembly moves.

Answers to some questions about hydraulic cylinder for vehicles:

How does the cylinder work?
Hydraulic transmission principle: oil as the working medium, through the change of the sealing volume to transfer movement, through the internal pressure of the oil to transfer power. 1. The power part - converts the mechanical energy of the prime mover into the pressure energy of the oil (hydraulic energy). For example: hydraulic pump. 2, the executive part - the hydraulic pump input oil pressure energy into the mechanical energy to drive the working mechanism. For example: hydraulic cylinder, hydraulic motor. 3, the control part - used to control and adjust the oil pressure, flow and flow direction. For example: pressure control valve, flow control valve and direction control valve. 4, the auxiliary part - the first three parts are connected together to form a system, which plays the role of oil storage, filtration, measurement and sealing.

How does the clamping cylinder work?
Hydraulic transmission principle: oil as the working medium, through the change of the sealing volume to transfer movement, through the internal pressure of the oil to transfer power. 1. The power part - converts the mechanical energy of the prime mover into the pressure energy of the oil (hydraulic energy). For example: hydraulic pump. 2, The executive part - the hydraulic pump input oil pressure energy into the mechanical energy to drive the working mechanism. For example: hydraulic cylinder, hydraulic motor. 3, The control part - used to control and adjust the oil pressure, flow and flow direction. For example: pressure control valve, flow control valve and direction control valve. 4, The auxiliary part - the first three parts are connected together to form a system, which plays the role of oil storage, filtration, measurement and sealing.