This article mainly introduces:

Peru hydraulic cylinder,pusher hydraulic cylinder manufacturer,pusher hydraulic cylinder

(Peru pusher hydraulic cylinder,produced by Hebei Hengyu company）

pusher hydraulic cylinder are widely used in Peru，because of simple structure and reliable operation，excellent temperature resistance，clever hydraulic energy conversion.So our company has designed pusher hydraulic cylinder for customers from Peru.

Introduction to pusher hydraulic cylinder:

The pusher hydraulic cylinder should be vented: when the pusher hydraulic cylinder is installed or parked for a long time to work again, the air will penetrate into the pusher hydraulic cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the pusher hydraulic cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the pusher hydraulic cylinder, the oil is best entered and discharged from the highest point of the pusher hydraulic cylinder. pusher hydraulic cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

If air enters the hydraulic system, the pusher hydraulic cylinder will not operate normally, mainly because there is a leak in the system. At this time, check the liquid level of the hydraulic tank, the seals and fittings on the oil suction side of the hydraulic pump, and whether the oil suction filter is too dirty. If so, the hydraulic oil should be replenished, seals and fittings should be treated, and the coarse filter element should be cleaned or replaced.

In the case of serious wear on the inner surface of the pusher hydraulic cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the pusher hydraulic cylinder manufacturing process for replacement. The pusher hydraulic cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

The pusher hydraulic cylinder is not the same as the pusher hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the pusher hydraulic cylinder can not be used as a high-power power component, but the pusher hydraulic cylinder can be used as a relatively large power component, or the pusher hydraulic cylinder system can be used.

Answers to some questions about pusher hydraulic cylinder:

Why the lifting cylinder falling by itself?
May be there is a pressure relief point. Check and repair the following parts: whether there is oil leakage in the transparent pipe at the top of the cylinder: the cylinder oil seal is broken, and the cylinder and oil seal need to be replaced; No: The multiway valve has pressure relief and needs to be repaired. Maintenance in accordance with routine maintenance items can reduce mechanical failures: 1. Check whether the thermostat works normally. 2, check the transmission shift work is normal. 3. Check the tightness of the fan belt. 4, check whether the diesel tank oil inlet filter is blocked or damaged, and clean or replace the filter. 5. Check and adjust the valve clearance.

Need to buy a hydraulic cylinder, now only know that the pressure needs to be between 20t and 50t. Two-way travel, how to determine the type of cylinder?
Important parameters of the cylinder: cylinder diameter, stroke, use pressure. First, the system pressure must be determined according to the precision of the operation of the application equipment, and the cylinder diameter can be determined by the force and system pressure. Then, according to how the equipment and the cylinder are installed and connected, determine the installation method of the cylinder and then determine the specific installation size, the size of the oil port, whether the buffer is needed and other details.